Change the Distribution Connection Type
This procedure describes how to modify the distribution Connection type of the distribution partner project that you have added either using Automatic or Manual mode.
- At least one project (started or stopped) is available under the Projects folder and you have enabled the distribution for this project.
- In the SMC tree, select Projects > [project].
- Depending on whether project is
Started
orStopped
, do one of the following:
- Click Edit .
- Click Change Distribution Info .
- Open the Distribution Participants expander.
- Select an entry for the distribution partner project.
- Open the Distribution Connection expander and perform the following steps:
- Modify the default distribution Connection type Bi-directional () to unidirectional () such that the Originator project (Local System) can see () the Partner project.
- Modify the default distribution Connection type Bi-directional () to unidirectional () such that the Originator project (Local System) will be seen () from the Partner project.
NOTE: When you click Sync, the Connection type is synced on the Partner System.
- Click Save Project .
- A distribution partner project entry is updated and saved with the updated Connection type.
- If the selected project is a running project and the Connection type changes from to any other Connection type or changes to from any other Connection type, a message displays asking you to restart the project.
- Click OK.
- Restart the project by licking Stop , and then clicking Start .